RF LINKS
-
OPSYS products enable RF Links for transmission of Analog signals from few HZ up to 40Ghz
-
We provide both Commercial off-the-shelf and Customized modules and rack mount units for harsh environment and industrial
-
Rack mounted products also support various of digital and discrete signals transmission over fiber for monitoring and control
-
Frequency ranges
-
Up to 6 GHz, Tx only, Rx only and full transceiver, extended temperature range, DWDM and optical amplification if needed.
-
Up to 22GHz, Tx only, Rx only and full transceiver, small form factor, extended temperature range, DWDM and optical amplification if needed.
-
For ordering information please refer to:
MTX
MTX is an Analog Electrical to Optical Transmitter designed for RF over Fiber applications and supports analog transmission signals. MTX-2 supports up to 2GHz, MTX-3 supports up to 3.5GHz and MTX-6 supports up to 6GHz. The module supports SM Fiber and standard connectors, SMA for RF input signal, LC or FC for optical output signal and 9-pin D-Type connector for power and control.
Its small form factor makes it ideal for systems where size is an issue, while its robust enclosure ensures performance in harsh environments and easy mounting.
A typical RF link would include MTX unit connected to MRX (Analog Optical Receiver unit).
MRX
MRX4 is an Analog Optical to Electrical Receive designed for RF over Fiber applications and supports analog transmission signals. MRX-2 supports up to 2GHz, MRX-4 supports up to 4GHz and MRX-8 supports up to 8GHz analog signals..
The module is designed for harsh environment. It is also available with a built-in RF Amplifier.
WTX
OPSYS high performance fiber optics analog transmitters are targeted for high end performance. analog transmission links
This product family is based on external modulation incorporating microprocessor control.
The product operates at 1550nm and optimized for Gain, Noise Figure and Dynamic Range performance
RTO
RTO is an Analog Optical Transceiver that supports bi-directional RF over Fiber transmission.
It supports Analog signals up to 3.5GHz
RTO is available in two configurations, dual and single fiber. Dual fibers supports bi-directional link over two separated Tx and Rx lines. Single fiber designed for one bi-directional link channel.
In/Out RF interfaces are standard SMA connectors and In/Out Optical interfaces are LC connectors. Power and control applied via standard 9-pin D-Type connector while its robust mechanical enclosure ensures performance in harsh environments, easy mounting and excellent thermal conductivity.